Qashqai 1 (2006-2013)

Front wheel hubs and steering knuckles — device (Nissan Qashqai J10)

0

1. Steering knuckle.

1. Steering knuckle.
2. Mudguard.
3. Wheel hub with bearing assembly.
4. Cotter pin.

Note. : replace the part with a new one after each removal.

(The source is indicated on the page: www.NissanBook.ru)

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Valeria Kuznetsova

Send this information to your friends:

◀ Previous

Qashqai 1: Transfer case and shafts

Next ▶

Checking the play of the rear main gear
Checking and adjusting the contact patch in the rear final drive engagement
Checking after disassembling the rear main gear
Checking the runout of the rear main gear connecting flange
Rear final drive — device

Front Wheel Hubs and Steering Knuckles — Removal and Installation
Front Wheel Hubs and Steering Knuckles — Checks
Front drive shafts — device
Removal and installation front drive shafts
Front Drive Shafts — Check

Similar information for other Nissan models

➜ Steering wheel and steering column — device Nissan Almera 1 (1995-2000)
➜ Replacing grease in front wheel hubs and checking bearings… Nissan Terrano 1 (1986-1995, petrol)
➜ Servicing front wheel hubs and drive shafts Nissan Patrol 4 (1987-1997, petrol)
➜ On-car maintenance — checking the front wheel steering angle Nissan X-Trail 2 (2007-2013, petrol)
➜ Front Axle — Front Wheel Hub and Steering Knuckle — On-Car… Nissan Note 1 (2004-2013)
➜ Removal and installation the front hub assembly with wheel… Nissan Maxima 4 (1994-1999)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.