Note: For disassembling and assembling the rear final drive, use the special tools and fixtures listed in the section "Service data and specification".
1. Filler cap.
2. Gasket.
3. Drain plug.
4. Back cover.
5. Lateral seal.
6. Side bearing adjusting shim.
7. Side bearing.
8. Driven gear (wheel) of the main transmission.
9. Differential box.
10. Satellite thrust washer.
11. Satellite.
12. Axle of satellites.
13. Locking pin.
14. Side gear thrust washer.
15. Side gear.
16. Drive gear (shaft-gear) main gear.
17. Rear bearing of the pinion shaft.
18. Adjusting lining of the pinion shaft.
19. Composite spacer.
20. Main gear housing.
21. Front pinion shaft bearing.
22. Pinion shaft nut.
23. Central seal.
24. All-wheel drive solenoid wires.
25. Electrically controlled clutch.
26. Coupling cover.
27. Threaded bolt.
28. Connector bracket.
29. Front oil seal.
30. Connecting flange.
31. Lock nut of connecting flange.
A. Seal edges.
B. Threaded hole.
Note.
: replace the part with a new one after each removal.
: apply transmission oil.
: apply anti-corrosion compound.
: Apply multi-purpose grease.
: Apply original sealant 1217 or equivalent.
: Apply original Three Bond 1322B medium strength threadlocker or equivalent.
: select thickness.