Table of contents: Removal ↓ Installation ↓
Removal
1. Disconnect the battery from ground.
2. Remove the rear seat back (see subsection 13.23).
3. Remove the inspection hatch.
4. Disconnect the connector from the sensor and immediately tape it to the body.
5. Mark the hoses and disconnect. Tape them to the body immediately.
6. Find the sensor position marks, if there are no marks, apply them.
7. Loosen the union nut by lightly tapping the screwdriver against the teeth of the nut.
8. Carefully lift the sensor, disconnect the filter from the tank and remove the sensor and filter assembly.
9. Remove the gasket.
10. Wash the filter and inspect it carefully. If it is clogged or damaged, replace it.
Installation
Installation is performed in reverse order. Replace the tank sealing ring, securely fasten the filter to the sensor, align the marks on the sensor and tank.