Throttle Position Sensor Pinouts (with manual transmission)
Throttle Position Sensor Pinouts (on automatic transmission)
Knock sensor terminals
| Type | Electronic fuel injection system controlled by the on-board computer system "Nissan" (ECCS) |
| Fuel Injected Engine Codes | GA14DE (1.4 l) and GA16DE (1.6 l) |
| Idle speed | cm. subsection 2.1 |
| Fuel pump | electric, located inside the gas tank |
| Fuel pressure at the regulator outlet | about 3.0 bar |
Data for verification
| Fuel pump winding resistance, | 0.7 Ohm |
| Throttle Position Sensor Resistance | See Fig. Throttle Position Sensor Pins (with manual transmission), Throttle Position Sensor Pins (on automatic transmission), Knock sensor terminals |
| Between terminals A and B or 1 and 2: | |
| - when the damper is completely closed | 0.5 kOhm |
| - when the damper is partially opened | 0.5 – 4 kOhm |
| - when the damper is fully open | about 4 kOhm |
| Injector resistance | 10 Ohm |
| Idle Speed Control Valve Resistance | 10 Ohm |
| Checking the winding of the idle speed control valve | When 12 V power is applied to the winding terminals, a click is heard |
| Power steering pressure sensor: | |
| - when turning the steering wheel | sensor contacts are open |
| - the steering wheel does not turn | contacts are closed |
| Coolant sensor resistance: | |
| – at 20°C | 2.2 – 2.9 Com |
| – at 90°C | 0.24 – 0.26 Com |
| – at 110°C | 0.14 – 0.15 Com |
Only approximate resistance values are given; before recognizing the sensor as faulty, consult with a car service center.
Recommended gasoline
| Cars with catalytic converter | Unleaded petrol with octane rating 95, refueling with leaded petrol is prohibited |
Tightening torques (Nm)
| Throttle Body Bolts: | |
| - Stage 1 | 10 |
| - 2nd stage | 20 |
| Fuel distributor bolts: | |
| - Stage 1 | 10 |
| - 2nd stage | 24 |
| Intake manifold bolts and nuts | 20 |
| Exhaust manifold bolts and nuts | 21 |
| Exhaust system mount | |
| Nuts for fastening the inlet pipe to the manifold | 32 |
| Bolt for fastening the inlet pipe to the bracket | 23 |
| Nuts for fastening the inlet pipe to the intermediate section (neutralizer) | 49 |
| Bolts for fastening the neutralizer to the end section | 49 |
| Bolts for fastening the intermediate section to the end section | 49 |