Table of contents: Models equipped with a window ↓ Models not equipped with a window ↓
Models equipped with a window
Removal
Components of the door glass and its drive mechanism
1 - screws; 2 - window; 3 - bolt; 4 - window glass; 5 - window lift handle; 6 - slider; 7 - retainer; 8 - finishing overlay; 9 - window regulator
1. Remove the interior handles, door trim panel and door polymer sealing film.
2. Working through the hole in the door panel, loosen the screws securing the window glass to the window lifter slider. Carefully lower the glass until it rests against the bottom of the door frame.
3. Locate the fasteners that secure the inner rubber sealing strip to the top of the inner door panel belt rail. Grasp the sealing strip near the fasteners and push it outward, releasing the fasteners one by one. Continue working until the strip is completely released from the door belt rail. Move the strip to the side.
4. Locate the fasteners that secure the outer sealing tape to the top of the outer door panel along the bottom edge of the window opening. Push the tape inward in the area of the fasteners, removing them one by one until the tape is completely released from the door frame.
5. Loosen the lower bolt securing the window guide channel.
6. At the front of the door frame, near the window, pull up a section of the rubber door seal sufficient to provide access to the window mounting screws. Remove the screws.
7. Tilt the window assembly back and, lifting it upwards, remove it from the window opening. In this case, to remove the lower bracket of the guide channel from the opening, the window will have to be turned 90°.
8. Carefully remove the window glass, being careful not to damage the paintwork of the door.
Installation
Installation is carried out in reverse order.
Data copied from web resource nissanbook.ru
1. Don't forget to adjust the position of the window frame to ensure smooth opening.
2. Loosely fasten the screws to the bottom edge of the window glass on the window lifter slider and lift the glass, pressing it firmly against the upper rear corner of the opening and against the rear guide channel. Once the glass is secured in this position, tighten the screws completely.
3. Before installing the polymer sealing film and door trim panel, check the proper functioning of the lock and window lift mechanisms.
Models not equipped with a window
Removal
Components of the door glass and its drive mechanism
1 - window glass; 2 - finishing overlay; 3 - screw; 4 - bolts; 5 - support bar; 6 - window lift handle; 7 - retainer; 8 - window regulator; 9 - nuts
1. Remove the interior handles, door trim panel and door polymer sealing film.
2. Working through the hole in the door panel, loosen the screws securing the window glass to the window lifter slider. Carefully lower the glass until it rests against the bottom of the door frame.
3. Locate the fasteners that secure the inner rubber sealing strip to the top of the inner door panel belt rail. Grasp the sealing strip near the fasteners and push it outward, releasing the fasteners one by one. Continue working until the strip is completely released from the door belt rail. Move the strip to the side.
4. Locate the fasteners that secure the outer sealing tape to the top of the outer door panel along the bottom edge of the window opening. Push the tape inward in the area of the fasteners, removing them one by one until the tape is completely released from the door frame.
5. Lift the glass, tilt it out of the rear guide channel and carefully remove it from the door.
Installation
Installation is carried out in reverse order.
1. Adjust the position of the front guide channel to achieve smooth glass lowering and raising.
2. Loosely fasten the screws to the bottom edge of the window glass on the window lifter slider and lift the glass, pressing it firmly against the upper rear corner of the opening and against the rear guide channel. Once the glass is secured in this position, tighten the screws completely.
3. Before installing the polymer sealing film and door trim panel, check the proper functioning of the lock and window lift mechanisms.