Attention:
Before removing the sunroof assembly, cover the seats and trim with rags to prevent damage.
After installing the sunroof assembly and glass cover, test for water leakage.
Preparatory work
Remove the glass cover.
Remove the interior ceiling trim.
Removing
1. Disconnect drain hoses (4 things.).
2. Disconnect the motor connector.
3. Disconnect the dome light wiring connector.
4. Unscrew the fixing bolts of the sunroof brackets from the side of the body and the sunroof block.
5. Remove the fixing nuts from the front and sides and remove the sunroof assembly from the roof panel.
Do not remove, but only loosen the nuts on the left side, indicated by the arrows, because they will be required to temporarily hold the block during installation.
6. When removing the sunroof from the passenger compartment, do not damage the seats and trim.
Installation
1. Temporarily secure the left sunroof bracket to the body.
2. Bring the block of the hatch in inside of the car and insert a forward edge into fixing bolts and nuts.
3. Tighten the fixing points diagonally, excluding those on the sunroof bracket around the opening.
4. Adjust the position of the brackets along the rails and the roof surface, tighten the bolts by hand, tighten the rail fasteners. Then tighten the sunroof bolts.
Note: Tighten the fasteners evenly so that the roof surface is not deformed.