Table of contents: Common use ↓ Using an air conditioner as a heater ↓ Windshield defogging ↓ Manual adjustment of air conditioner…↓
Common use
By following the steps below, you can maintain comfortable conditions in the cabin automatically (except for the defogging mode).
1. Press switch A to turn on AUTO mode (the display will show the word AUTO).
Note: If, while the air conditioner is operating in automatic mode, you manually change the air flow volume or blowing direction, the display shows MANUAL, but all parameters, except those changed manually, continue to be adjusted automatically.
2. If the indicator on the D button for turning on the air conditioner is not lit, press this button.
3. Use knob B to set the desired temperature. Temperature adjustment range: 18-32°C. Turning it clockwise increases the temperature, turning it counterclockwise decreases it.
4. If the indicator on the air recirculation switch (button F) or outside air intake (button E) is on, press the corresponding switch and turn off the indicator.
To turn off the air conditioner, press the OFF button (button C).
Note:
When the ambient temperature drops to approximately 0°C, cooling and reducing the humidity in the passenger compartment becomes impossible.
Immediately after starting the engine, when the coolant temperature is low, a weak flow of air is supplied to the feet.
When the outside temperature is low, a larger volume of air is supplied to the windshield.
Using an air conditioner as a heater
1. Press button A of the automatic air conditioner mode switch (the display will show the word AUTO).
2. If the indicator on the D button for turning on the air conditioner is on, press this button (the indicator will go out).
3. Turn knob B to set the desired temperature.
After completing these steps, the air conditioner will operate as an automatically controlled heater.
Note:
When using the air conditioner as a heater, it is impossible to set the interior temperature below the ambient temperature.
This mode is used in case of low outside temperature and humidity.
Windshield defogging
Press the windshield defroster switch G (the indicator on the button lights up and the display shows
. The system will switch to outside air intake, and air will flow from the corresponding deflectors onto the windshield.
After pressing the windshield defroster switch, do not turn on the air recirculation mode, this will make it difficult to remove fog.
If you set the temperature to low when the outside temperature is low, the outside of the windshield may fog up.
To quickly remove fog, increase the temperature and air flow volume.
To return the air conditioner to its previous mode, press switch G again.
Manual adjustment of air conditioner operating modes
Changing the volume of air flow
Each time you press switch H, the air flow volume switches as follows: (the display will show MANUAL).
Switching the blowing direction
Each time switch I is pressed, the following changeover of the blowing direction occurs: (the display will show MANUAL).
Switching between recirculation and outside air intake
To turn on the recirculation mode, press switch F (the indicator on the switch will light up).
To turn on the outside air intake mode, press switch E (the indicator on the switch will light up).
To return to the original position, press the same switch again (the indicator on the switch will go out).