Removing
1. Disconnect the battery from the ground.
2. Raise the lid.
3. Detach the inner cover panel by releasing the latches.
4. Disconnect the connector and pull the connector and wiring out of the cover by tying the cord and removing the seal. Leave the cord in the lid.
5. Mark the position of the hinges relative to the cover.
6. Supporting the cover, unscrew the bolts and remove the cover
Installation
1. Install the cover with two people, tighten the hinge bolts, align with the marks and tighten the bolts.
2. Pull the wire through the cover, tying it to the cord.
3. Adjust the cover.
Adjustment
1. Close the cover and check the gaps with adjacent body panels. If necessary, loosen the hinge bolts and adjust the position of the cover, tighten the bolts.
2. After adjusting the hood, check the operation of the lock and adjust. Loosen the lock bolts, adjust the position and tighten the bolts.