Removal
1. Raise the rear of the vehicle and support it on stands.
2. Remove the wheel.
3. Unscrew the nuts (indicated by an arrow) fastening the rods to the rack.
4. Loosen the bolts securing the stabilizer to the body bracket (indicated by arrows).
5. Remove the stabilizer cross member.
Examination
If necessary, replace the buffers, installing them so that the slots face up.
Installation
1. The stabilizer is installed in the reverse order.
2. The notch for the bolt in the clamp should be facing downwards. The hinge of the stabilizer rod should be located in the center of the arc described by the rod when it is displaced. In this position, the hinge should be completely unloaded (A - slot, B - clamp, C - stabilizer, D - rod).
3. Replace the stabilizer and tie rod nuts.
Stabilizer link
Removal and installation
1. Raise the rear of the vehicle and support it on stands.
Information obtained from the website [nissanbook]
2. Remove the wheel.
3. Loosen the nut securing the rod to the stabilizer crossmember.
4. Loosen the nut securing the rod to the rack and remove the rod.
5. Check the condition of the tie rod joints and replace if necessary.
6. The rod is installed in the reverse order.
7. Replace the tie rod nuts.
8. The hinge of the stabilizer rod must be located in the center of the arc described by the rod of its displacement. In this position the hinge must be completely unloaded.