Bearings are changed only in assembly with the hub.
1. To remove the hub, lift the rear of the vehicle and place it on stands.
2. Remove the wheel.
3. On vehicles with rear disc brakes, remove the disc and caliper without disconnecting the hose.
4. On vehicles with rear drum brakes, remove the drum.
5. Remove the hub cap and unpin the axle nut.
6. Loosen the hub nut.
7. Loosen the nut, remove the washer and hub.
8. Clean the axle and put on a new hub with bearing.
9. Put on the washer and tighten the nut (replace washer and nut).
10. On vehicles with drum brakes.
11. On vehicles with disc brakes, install the disc and caliper.
12. Tighten the nut to the specified torque.
13. Check the freedom of rotation of the hub, cotter the nut with a new cotter pin and press the cap.
14. Install the wheel and lower the car.