Removing
1. Raise the rear of the car and place on stands.
2. Remove the wheel.
3. Loosen axle nuts (indicated by an arrow) levers on the hub housing.
4. If the levers will change, then mark their position by making marks on the eccentrics of the bolts for attaching the levers to the body brackets and on the brackets (wheel alignment is adjusted by eccentrics).
5. Turn away nuts of bolts of fastening of levers to a body, get the eccentric and a bolt.
6. Remove levers (the arrows indicate the nuts of the bolts of the levers to the body brackets). When removing, remember the location of the bolts.
Examination
1. Check the condition of the levers and bushings.
2. The levers change only assembled with bushings.
Installation
1. Install the levers in the brackets and skip the bolts, installing them in the same order.
2. Install washers and tighten new nuts.
3. Insert the axle of the levers from the rear side of the hub housing, put on the washers and tighten the new nuts.
4. Install the wheel and lower the car.
5. Roll the car forward and backward, rock up and down.
6. Tighten the nut of the outer axis of the levers.
7. Set the eccentrics according to the marks, check the toe-in of the rear wheels and tighten the nuts to the specified torque (A - negative toe, B - positive toe, 1 - right side, 2 - left side).
8. If the convergence cannot be checked, then tighten the nuts, and then contact a service station.