Removal
1. Raise the rear of the vehicle and support it on stands.
2. Remove the wheel.
3. Loosen the rod nut on the hub body and remove the washer.
4. Unscrew the nut (indicated by arrows) rods on the body bracket and remove the rod.
Examination
1. Check the rods and bushings.
2. The rods are changed only as a set with bushings.
Installation
1. Install the rod onto the stud in the hub housing and screw on a new nut.
2. Install the rod onto the bracket, pass the bolt through and screw on a new nut.
3. Install the wheel and lower the vehicle.
4. Roll the car forward and backward, rock it up and down.
5. Tighten all nuts to the specified torque.