Table of contents: Adjustment of the leading edge…↓ Height adjustment on the sides of…↓
Adjustment of the leading edge height and clearance in the longitudinal and transverse directions
1. Remove the hood lock and adjust the height by rotating the rubber shock absorber so that the hood is 1-1.5 mm lower than the wing.
2. Tighten the hood lock by hand and engage it with the latch. Make sure there is no play in the hood lock and latch. Tighten the hood lock mounting bolts to the specified torque.
Attention:
Adjust the right/left gap between the hood and other components as follows:
Bonnet (B) - Headlight (B): 1.5mm or less
Bonnet (C) - Headlight (C): 1.0 mm or less
Height adjustment on the sides of the hood
1. Remove the hood lock by rotating the rubber shock absorber (right and left), make sure that the difference in height of the hood, fenders and headlights is equal to the size specified below
Hood (C) - Wing (C): from -1.0 to 1.0 mm
2. Temporarily install the hood latch. Move the hood latch left or right until the centers of the latch and lock are vertical when viewed from the front.
3. Ensure that the secondary bonnet lock latch engages securely with the secondary latch loop by releasing it from a height of approximately 200 mm or by applying light pressure with a force of approximately 3 kg.