Preparatory work
Remove the front right wheel.
Remove the right engine protection from the bottom.
Remove the right mudguard.
Drain the coolant.
Remove drive belts.
Remove the crankshaft pulley.
Remove the front engine mount insulator. (see point 1)
Front engine mount insulator
Removing
Jack up the oil pan, remove the front engine mount insulator, then gradually lower the front of the engine.
Installation
See ch. mechanical part of the engine.
Water pump
Removing
Lean a block of wood against the water pump and lightly tap the block with a hammer to remove the pump.
Installation
Apply Three Bond 1207C in a continuous bead (KR51000150) as shown in fig.