Gear ratio change characteristics (standard data)
Note: After the torque converter lockup is complete, while driving at a speed of approximately 18-40 km/h.
Standard values of input/output signal voltages at the CVT control unit connector contacts (Nissan Serena C24)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Sofia Shapovalova
Similar information for other Nissan models
➜ Remote door lock control system — standard voltage values… Nissan Note 1 (2004-2013)
➜ Checking the voltage at the engine control unit connector Nissan Almera 1 (1995-2000)
➜ Precautions when replacing the electronic transmission… Nissan Qashqai 1 (2006-2013)
➜ Control unit — removal and installation Nissan Sunny 7 (1990-1998)
➜ Control and measuring system units with ECCS processor unit Nissan Terrano 1 (1986-1995, petrol)
➜ Electronic control unit (ECM) Nissan Murano 1 (2002-2007, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Control devices
- User manual
- Power unit
- Petrol engine SR20DE
- Diesel engine YD25DDTi
- Cooling and lubrication system
- Engine management SR20DE
- Engine management YD25DDTi
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive and cardan shafts
- Transfer case
- Chassis
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body
- Safety system
- Interior (internal elements)
- Exterior (external elements)
- Doors, locks and windows
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Lighting system
- Windshield wipers and washers
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.