Checking CVT Oil
Check oil level and leaks.
Check the condition of the oil.
Selector Lever Shift Control
Check and adjust the range switch.
Checking line pressure
1. Check the engine oil level. Top up if necessary.
2. Warm up the CVT oil to operating temperature of 50-80°C after driving the car for about 10 minutes. Then check the CVT oil level. Top up if necessary.
Note: At an ambient temperature of 20°C, after 10 minutes of driving in the urban driving cycle, the oil temperature in the CVT rises to 50-80°C.
3. After warming up the CVT, unscrew the plug of the inspection hole for checking the pressure and install a pressure gauge there (special tool ST2505S001).
Caution: Use special tool ST25480000 to remove and install the inspection hole plug.
4. Apply the parking brake fully and lock the wheels.
5. Start the engine and measure the line pressure at idle and at full throttle.
Attention:
While measuring, press the brake pedal all the way down.
When measuring pressure with the throttle valve fully open, see the section below "Check on a stationary vehicle".
6. After completing the work, replace the inspection hole plug and tighten it to the required torque.
: 5,0-6,8 N·m (0.5-0.7 kg·m)
Caution: Since the threads of the plug are coated with adhesive, do not reuse the removed plug.
Normal line pressures
MRa (kg/cm²)
