Table of contents: Removal ↓ Installation ↓
Removal
1. Remove the steering column covers and lower instrument panel section on the driver's side.
2. Squeeze the slider latches on the cable, slide it towards the cable sheath cap and remove the rod and the regulator holder.
3. Remove the cable sheath cap from the bracket.
4. Remove the holder mounting clip from the ignition lock cylinder and remove the cable.
Installation
Caution: Once the cable is removed, do not reuse it, replace it with a new one.
1. Turn the ignition key to the ACC or ON position, attach the cable holder to the ignition switch and secure with the clamp.
Caution: Do not reuse the clamp.
2. Turn the ignition key to the LOCK position.
3. Set the automatic transmission selector lever to position P, connect the cable adjuster holder to the control mechanism rod.
4. Install the cable sheath cap onto the control mechanism bracket.
Attention:
Do not twist or bend the cable during installation.
After installing the cable on the control mechanism, make sure that the cable sheath cap and bracket are securely fastened.
5. To prevent the slider on the cable from touching other parts, move it towards the rod, firmly secure the regulator holder and rod.
Attention:
After installing the slider, do not press on its latches.
When sliding the slider, do not apply force in the transverse direction of the rod.
6. Install the steering column covers and lower instrument panel section on the driver's side.