Note 1 (2004-2013) Micra 3 (2002-2010, petrol)

Floor finishing — removal and installation (Nissan Note E11)

Table of contents: Removal ↓ Installation ↓

1. Floor covering; 2. Steering column shaft cover; 3. Front floor trim, left; 4. Front floor trim, right; 5. Front center floor trim, left; 6. Front center floor trim, right; 7. Rear floor trim, left; 8. Rear floor trim, right

Removal

1. Remove the front seats (left and right) and the rear seat cushion.

2. Remove the center console. See section "Central console".

3. Disconnect the electrical connector from the airbag sensor unit. See Chapter Additional passive safety system.

4. Remove the instrument panel pillar cover. See section "Dashboard".

5. Remove the lower center pillar trim (left and right).

6. Partially remove the front and rear body side panel curbs (left and right).

7. Remove the side trim of the instrument panel partition (left and right). See section "Side body trim".

8. Unfasten the hooks of the floor covering.

9. Remove the floor covering from the vehicle.