Engine thermostat HR16DE:
1. Upper radiator hose.
2. The inlet pipe of the cooling system.
3. Rubber ring.
4. Thermostat.
A. To the radiator.
Conclusion of the HR16DE engine cooling system:
1. Coolant temperature sensor.
2. Washer.
3. Gasket.
4. Upper radiator hose.
5. Conclusion of the cooling system.
6. Heater hose.
7. Heater hose.
8. Water hose (models for Northern Europe).
9. Water hose (models for Northern Europe).
A. To the electronic throttle actuator.
B. To the heater core. C. To the radiator.
1. Heater hose.
2. Conclusion of the cooling system.
3. Coolant temperature sensor.
4. Washer.
5. Water hose.
6. Water hose.
7. Gasket.
8. Coolant control valve.
9. Rubber ring.
10. Water hose.
11. Expansion tank hose (models with manual transmission).
12. Upper radiator hose.
13. Water hose (models with variator).
14. Heater hose.
A. Kororireayu.
B. To the drive of the electronic diossyl damper.
C. To expansion tank.
D. To oil cooler.
E. To the radiator.
F. CVT fluid cooler.
Lose MR20DE engine:
1. Thermostat housing.
2. Clamp (modifications with a variator).
3. Water hose (modifications with a variator).
4. Heater thermostat (modifications with a variator).
5. Water hose (modifications with a variator).
6. Lower radiator hose.
7. Collar.
8. Inlet pipe of the cooling system.
9. Thermostat.
10. Rubber ring.
11. Gasket.
A. To the CVT fluid cooler.
B. To the radiator.
C. To oil cooler.
Note.
- The white arrow points to the front of the engine.
- Replace the part with a new one after each removal.