Serena 2 (1999-2005)

Ignition switch (Nissan Serena C24)

0

Examination

Using a tester, check the conductivity between the ignition switch contacts in all positions.

Using a tester, check the conductivity between the ignition switch contacts in all positions.

The article was copied from here nissanbook.ru

This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

This article has been reviewed: Sofia Shapovalova

Send this information to your friends:

◀ Previous

Serena 2: Engine management YD25DDTi

Next ▶

Engine quick warm-up switch
Accelerator Pedal Switch — Check
Idle switch and full accelerator pedal switch
Coolant temperature sensor
Mass air flow sensor

Brake light switch
ABS Wheel Sensors (Vehicle Speed Signal) — Checking, Removing and Installing
Control lamp and glow relay
Glow Relay — Removal
Glow plugs

Similar information for other Nissan models

➜ Checking the proper functioning and replacing the ignition… Nissan Maxima 4 (1994-1999)
➜ Ignition Switch — Removal and Installation Nissan Terrano 1 (1986-1995, petrol)
➜ Removal and installation the ignition switch Nissan Patrol 4 (1987-1997, petrol)
➜ Ignition switch and ignition switch Nissan Sunny 7 (1990-1998)
➜ Ignition switch Nissan X-Trail 2 (2007-2013, petrol)
➜ Ignition switch Nissan Note 1 (2004-2013)

Link in different formats to this article

TEXTHTMLBB Code

Comments and feedback from visitors

No comments yet

Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.