2. Install the oil chute.
3. With a punch (special tool) Press the matched shim and ring gear bearing outer race into the adapter housing.
4. With a punch (special tool) press the gland until it is flush with the end face of the body.
Attention:
If the total preload was measured when the oil seals were removed, repeat the measurement after the oil seals are installed.
Do not reuse seals.
Apply Nissan MP Special Grease #2 to the lips of the oil seal and apply Nissan Differential Gear Hipoid Oil Super GL-5 80W-90 to the oil seal seating surface.
5. Apply sealant 1215 (KP61000 250) on the drain plug thread. Screw the plug into the drain hole and tighten to the required torque.
Drain plug:
: 10-19 N-m (1.0-2.0 kg m)
6. Apply a thin bead of Nissan MP Special Grease #2 to the O-ring and insert it straight into the adapter body.
Attention: Do not reuse the O-ring, replace it with a new one.
7. Install the adapter body on the transfer case housing, apply anti-corrosion oil to the threads and seating surfaces of the mounting bolts and tighten them to the required torque.
: 14-16 Nm (1.4-1.7 kgm)
8. Check the play, preload and the shape of the contact patch in the meshing of the gear teeth, see above.
Caution: If the total preload was measured when the oil seals were removed, repeat the measurement after the oil seals are installed.