The crankshaft angle sensor is part of the distributor and cannot be replaced separately. If the sensor is faulty, the entire distributor must be replaced (see subsection 7.7.4).
The source is published on the portal nissanbook.ru
Crankshaft angle sensor (Nissan Sunny B13)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Crankshaft angle sensor (built into the distributor) Nissan Serena 2 (1999-2005)
➜ Distributor/Crankshaft Angle Sensor — Removal and… Nissan Bluebird T12 (1986-1991)
➜ Checking the condition and replacing the crankshaft… Nissan Maxima 4 (1994-1999)
➜ Crankshaft position sensor (POS) Nissan Murano 1 (2002-2007, petrol)
➜ Crankshaft speed sensor — check Nissan Terrano 1 (1986-1995, petrol)
➜ Steering wheel angle sensor (versions with ESP) Nissan Qashqai 1 (2006-2013)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Faults en route
- Maintenance
- Power unit
- Petrol engines (1.4 and 1.6)
- Engine overhaul (1.4 and 1.6)
- Petrol engines (2.0)
- Engine overhaul (2.0)
- Diesel engine
- Cooling system
- Heating and ventilation
- Power system (carburetor)
- Power system (injector)
- Fuel injection system
- Single point injection
- Multi-point injection
- Decreased toxicity
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Body repair
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.