ATTENTION! To boost the ignition spark, use 12 volt batteries.
1. Set the key to position "OFF".
2. Remove the vent caps from the battery pack (if any). Cover the battery with a rag as shown.
3. Connect the jumper wires in the sequence shown in the figure.
ATTENTION! Incorrect connection may damage the charger.
4. Start the engine of another machine and let it run for a few minutes. While holding the engine at 2000 rpm, start your car's engine in the normal manner.
5. After starting your engine, carefully disconnect the wire first from the positive pole and then from the negative.
6. Replace the ventilation caps (if any).
ATTENTION! Be careful when connecting and disconnecting wires. Do not allow the positively charged wire to come into contact with the body or the negative wire.