- There is no clear fixation of the selector.
- The included range pointer is set incorrectly.
- The cable was disconnected from the selector or control lever.
Installation
1. Set the selector and control lever to position P.
2. Attach the cable to the selector lever and tighten the cable lock nut. Secure the cable with a clamp to the selector lever bracket.
3. Attach the cable to the control lever and secure with a clip to the gearbox bracket.
4. Pull the cable in the direction of the arrow with a force of 6.9 N (0.7 kgf).
5. Pull the cable back 1 mm and tighten the lock nut.
6. Move the selector lever from position P to position 1. The lever should move smoothly, without sliding noise.
7. Apply grease to the contact surfaces of the lever and cable. Install all removed parts.
Adjustment
Loosen the lock nut of the cable from the side of the gearbox and follow the steps described in paragraphs 4-7 of subsection «Installation».