Examination
Check the power window assembly as indicated below. If abnormalities are found, replace or apply lubricant.
Check:
- is the cable worn out;
- whether the window regulator is deformed;
- the state of lubrication in the sliding areas.
Apply lubricant (special grease No. 252) to the areas indicated by the arrows.
Driver's window adjustment
Resetting the limit switch to its original position
After completing the work listed below, it is necessary to return the limit switch to its original position.
- Removing the power window;
- Removing the e / engine from the power window;
- Operation of the power window in the removed state;
- Removing glass;
- Removing the glass guide.
Limit switch reset procedure
The return procedure is made after the final assembly of all components.
1. Raise the glass up to the stop.
2. Press the switch and completely to the stop lower glass down.
3. Disconnect the switch, lift glass up against the stop and establish the switch into place.
Attention: Do not lift the glass up in automatic mode.