Removal
1. Disconnect the cable from the cam on the throttle body.
2. Loosen the nuts of the cable sheath to the bracket and remove the cable sheath from the bracket (the arrow shows the throttle cable adjusting nut).
3. Release the cable along the entire laying route.
4. In the passenger compartment, remove the lower panel on the driver's side.
5. Disconnect the cable from the pedal.
6. Loosen the nuts securing the casing to the engine compartment bulkhead and remove the cable, pulling it into the engine compartment.
Installation
1. Route the cable through the engine compartment bulkhead.
2. Pull the cable into the engine compartment and place it in place.
3. Secure the cable sheath to the engine compartment bulkhead with nuts.
4. Attach the cable to the pedal.
5. Install the bottom panel.
6. Secure the cable sheath along the entire route.
7. Attach the cable to the cam on the throttle shaft.
8. Adjust the cable.
Adjustment
1. Loosen the adjusting nuts, make sure that the cam rests against the stop.
2. Tighten the far nut, as soon as the cam starts to move, loosen the nut by 1.5-2 turns and tighten the lock nut.
3. Have an assistant press the pedal and check for smooth cam movement.