Front doors
Components for installing glass and power windows of the front door
1 - Door; 2/3 - Lower front / rear guide; 4 - Top guide; 5 - Power window; 6 - Screw
1. Remove the door trim panel (see Section Removing and installing door trim panels) and fully raise the glass.
2. Disconnect the front speaker connector and remove the seal.
3. On 5 door models remove the inner frame of the front door.
4. On models with the system «Intelligent Key» remove buzzer.
5. Turn out bolts of fastening of the lower back directing, move the lower part of directing forward and pull out it from a door.
6. Holding the glass with your hand and operating the power window switch, set the glass to a position in which its fixing bolts will be accessible. Turn out bolts of fastening of glass.
7. Take the glass out of the door by pulling on its rear edge.
8. Separate a socket and turn out bolts of fastening of the e/motor of a window regulator. Remove the power window assembly.
9. Remove the bottom forward directing of glass similarly back.
10. Remove the corner trim and top guide.
11. Installation is carried out in the reverse order.
12. After installation, program the power window. To do this, fully raise the window, then press the reset switch to fully lower the window. Release the switch. After it returns to its original position, raise the glass.
Rear doors
Components for installing glass and rear door power window
1 - Door; 2 - Fixed glass guide; 3 - Sliding glass guide; 4 - Seal; 5 - Glass; 6 - Fixed door glass; 7 - Power window
1. Remove the door trim panel (see Section Removing and installing door trim panels), disconnect the rear speaker wiring connector and remove the seal.
2. Remove the bolts and screws securing the fixed glass guide, pull it down, pull back the top side and remove the guide.
3. Remove the fixed glass by pulling it towards the front of the vehicle.
4. Holding the glass with your hand and operating the power window switch, set the glass to a position in which its fixing bolts will be accessible.
5. Turn out bolts of fastening of glass and take glass from a door, having pulled its top.
6. Separate a socket, turn out bolts of fastening of assembly of a window regulator and remove it.
7. Remove the sliding glass guide.
8. Installation is carried out in the reverse order.