Standard voltage values on the contacts of the VSM block
Attention:
Check the waveform at the combination switch terminals under power with the headlight switch, turn signal switch and wiper switch off so as to avoid oscillation from overload.
Turn the wiper dial to position «4», except for the case of checking the waveform or voltage at a certain position on the wiper scale. The position of the wiper scale can be confirmed with the CONSULT-II tester.
*1: Left hand drive models
*2: Right hand drive models
Note: The light and rain sensor must be exposed to steady light. If the light and rain sensor is not well lit, the measured value may not be correct.