Table of contents: Garage jack, safety stands and…↓ Side lift ↓
Attention:
- Raise the vehicle when it is unloaded.
- Since when removing the main units from the front of the car (engine, gearbox, suspension, etc.) the vehicle's center of gravity is shifting, support the vehicle from behind with a garage jack or equivalent device.
- Since when removing the main units from the rear of the vehicle (rear axle, suspension, etc.) the vehicle's center of gravity is shifting, support the vehicle from the front with a garage jack or equivalent.
- Be careful not to damage the pipes that run underneath the vehicle.
Garage jack, safety stands and 2-post lift
Attention:
- To lift the car with a jack, stop it on a level surface. Do not damage the pipes running under the bottom of the car.
- Do not climb under the vehicle when it is supported by a single jack. Do this only after placing safety stands.
- Place chocks in front and behind the wheels that are on the ground.
- When lifting the vehicle, spread the lift arms as wide as possible and make sure the front and rear of the vehicle are well balanced.
- When placing the lift arms under the vehicle, do not allow them to touch the brake lines, parking brake cable, fuel lines or sill spoiler.
Safety stand mounting points (front) |
Safety stand mounting points (rear) |
[Information copied from the portal: NISSANBOOK]
Garage jack support points (front) |
Garage jack support points (rear) |
Side lift

Attention:
- When lifting the vehicle, make sure there is no one in it.
- The side lift attachment, installed at the front of the vehicle, should be placed in front of the threshold under the front door opening.
- Place the attachments at the front and rear ends of the side lift.