Almera 1 (1995-2000)

Removal and installation of the GA engine (Nissan Almera N15)

Table of contents: Removal ↓ Installation ↓

1. Front engine mount
2. Front cylinder head bracket
3. Front support bracket
4. Rear support bracket
5. Gearbox support
6. Gearbox support bracket
7. Rear engine mount
8. Dynamic damper (models with automatic transmission)
9. Central beam
10. Buffer bracket
11. Buffer

WARNINGS:

Do not remove the engine until the exhaust system has cooled.

Before disconnecting the fuel lines, relieve the pressure in the fuel system (see chapter "Engine management system").

For engines not equipped with lifting eyes, install the eyes described in the spare parts catalog.

Do not remove the engine separately from the gearbox.

Removal

1. Drain the cooling system.

2. Remove the hood.

3. Remove the battery.

4. Remove the expansion tank and bracket.

5. Remove the drive belts.

6. Remove the generator, air conditioning compressor and power steering pump from the engine.

There is no need to disconnect the lines from the power steering pump

1. Remove the following parts:

Right and left front wheels.
Engine mudguards.
Brake calipers.
There is no need to disconnect the brake hoses from the calipers.
Disconnect the tie rod ends from the steering knuckles.
Right and left drive shafts. When removing the drive shafts, be careful not to damage the gearbox seals.
Disconnect the control rod and torque rod from the gearbox (manual transmission)
Disconnect the control cable from the gearbox (automatic transmission).
Central beam.
The exhaust pipe.
Anti-roll bar.
Cooling system fan.
Radiator.
Front cylinder head bracket. Air duct.
Disconnect wires, hoses, lines, etc.

Source is available on the resource: NISSANBOOK.ru

8. Raise the engine and disconnect or remove the engine mounts.

When lifting the engine, be careful not to hit nearby parts, especially the brake lines and master cylinder.

9. Remove the engine with gearbox as shown in the figure.