Table of contents: Removal and installation - SR engine ↓ Removal and installation - CD engines ↓
Removal and installation - SR engine
1. Remove the drive belts.
2. Remove the cylinder head (see chapter "Engine").
3. Remove the oil pan (see chapter "Engine").
4. Remove the oil receiver and partition.
5. Remove the front crankcase (see chapter "Engine").
6. Installation is carried out in reverse order.
Removal and installation - CD engines
1. Drain the coolant and oil.
2. Remove the lower radiator hose, drive belts, crankshaft pulley, timing belt covers and timing belt.
3. Disconnect the exhaust pipe, remove the crankshaft sprocket and the rear engine support bracket. Then remove the oil pan.
4. Remove the crankshaft position sensor (CD2011).
5. Remove the oil pump together with the oil receiver.
6. Installation is carried out in reverse order.
Apply sealant to the oil pump mounting surface as shown in the figure.
The installation of the oil pan is carried out according to the description in the chapter "Engine".
