Check and adjustment
Check up uniformity of an arrangement of petals of a diaphragm spring on height, without removing a casing of coupling.
Permissible spread (at the ends of the petals), mm:
- Model 180 - 1.0
- Models 190, 200 and 215 - 0.7
If the specified value is exceeded, adjust the height of the petals using the special tool.
Flywheel check
WARNING: Do not allow magnetized objects to come into contact with the flywheel ring gear.
Check the flywheel running surface for burn marks and discoloration. If necessary, clean the flywheel with sandpaper. Check flywheel runout (see chapter «Engine», chapter «Cylinder Block - Check»).
Installation
When installing the clutch cover with the driven disc, insert the mandrel into the hub of the driven disc.
Do not allow grease to get on the friction linings of the driven disk.
Tighten the clutch cover mounting bolts in the order shown, in two steps.
- The first stage - 10-20 Nm
- Final tightening - 22-39 Nm