Removing
1. Disconnect the negative battery terminal.
2. Remove the drive belt.
3. Disconnect the generator connector (1).
4. Loosen the nut (2) and disconnect the terminal «IN».
5. Turn off the top bolt of fastening of the generator (3).
6. Completely unscrew the lower alternator mounting bolt and pull so that the bolt head rests against the side rail. After that, remove the generator by pulling it up.
Note. The alternator can be removed with the bolt by pulling it forward using the notch on the thermostat housing bolt.
7. Remove the alternator up from the vehicle.
Installation
Installation is made in an order, the return to removal.
Attention. Make sure that the output nut «IN» tightened securely.
Note.
- Start the alternator bolts in order from bottom to top, then tighten them to the final tightening torque from top to bottom.
- Front side of the generator (pulley side) is the original surface. Place the original surface of the generator on the installation area, then tighten the mounting bolts.
Note. After installing the alternator, check the drive belt tension.