Removing
1. Disconnect the negative battery terminal.
2. Remove the engine cover.
3. Partially remove the right fender liner.
4. Remove the drive belt.
5. Remove the intake duct.
6. Remove the cooling fan assembly and heatsink mounting brackets.
7. Remove intake duct (1).
8. Remove air inlet hose (2) from the generator removal area.
9. Unscrew the bolts of the bracket (A) and remove bracket (3) expansion tank hose.
10. Disconnect the generator connector (IN).
11. Loosen the nut (WITH) output "IN" and disconnect the wire from the output.
12. Unscrew the top bolt of the generator (D).
13. Completely unscrew the lower generator mounting bolt (E) and remove it so that the bolt head rests on the side member. After that, remove the generator by pulling it up.
Note. The alternator can be removed with the bolts upwards using the bolt cutout in the alternator bracket.
14. To remove the generator from the car upwards.
Installation
Installation is made in an order, the return to removal.
Attention. Make sure that the output nut "IN" was securely tightened.
Note. Temporarily fasten the alternator bolts (bottom first, then top), and then tighten (top first, then bottom).
Attention. Front side of the generator (pulley side) is the original surface. Place the original surface of the generator on the installation area, then tighten the mounting bolts.
Note. After installing the generator, it is necessary to check the tension of the drive belt.