- Limit bending: 0.15 mm (per 100 mm length)
- Torsion Limit: 0.3mm (per 100 mm length)
The article is located on the website [NissanBook]
The article is located on the website [NissanBook]
Bending and twisting of the connecting rod (Nissan Serena C24)
Perform a check using a connecting rod end alignment tester.
The article is located on the website [NissanBook]
The article is located on the website [NissanBook]
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Sofia Shapovalova
Similar information for other Nissan models
➜ Hydraulic system — disconnecting and connecting Nissan Almera 1 (1995-2000)
➜ Removal connecting rod and piston assemblies Nissan Maxima 4 (1994-1999)
➜ Pistons and connecting rods — removal Nissan Murano 1 (2002-2007, petrol)
➜ Connecting rod and piston group — dismantling Nissan Terrano 1 (1986-1995, petrol)
➜ Rules for connecting diagnostic equipment Nissan Patrol 4 (1987-1997, petrol)
➜ Pistons and connecting rods — removal and installation Nissan Primera 1 (1990-1996, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- Control devices
- User manual
- Power unit
- Petrol engine SR20DE
- Diesel engine YD25DDTi
- Cooling and lubrication system
- Engine management SR20DE
- Engine management YD25DDTi
- Power and exhaust system
- Transmission
- Automatic gearbox
- Drive and cardan shafts
- Transfer case
- Chassis
- Front suspension
- Rear suspension
- Brake system
- Steering
- Body
- Safety system
- Interior (internal elements)
- Exterior (external elements)
- Doors, locks and windows
- Heating and air conditioning
- Electrical equipment
- Equipment and devices
- Lighting system
- Windshield wipers and washers
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.