Cm. subsection 3.1.1.5.
If the pulley cannot be removed due to a tight fit on the crankshaft nose, you can use a puller. There are threaded holes in the pulley to attach the puller.
The article is located on the website [NISSANBOOK.RU]
Crankshaft pulley (Nissan Sunny B13)
This article is available at: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
This article has been reviewed: Valeria Kuznetsova
Similar information for other Nissan models
➜ Removal and installation the crankshaft pulley Nissan Maxima 4 (1994-1999)
➜ Crankshaft pulley — removal and installation Nissan Murano 1 (2002-2007, petrol)
➜ Crankshaft pulley — removal, inspection and installation Nissan Terrano 1 (1986-1995, petrol)
➜ Replacing the front crankshaft oil seal Nissan Almera 1 (1995-2000)
➜ Replacing crankshaft seals Nissan Patrol 4 (1987-1997, petrol)
➜ Crankshaft and crankshaft bearings — removal, inspection… Nissan Primera 1 (1990-1996, petrol)
Link in different formats to this article
Comments and feedback from visitors
No comments yet
- General information
- User manual
- Faults en route
- Maintenance
- Power unit
- Petrol engines (1.4 and 1.6)
- Engine overhaul (1.4 and 1.6)
- Petrol engines (2.0)
- Engine overhaul (2.0)
- Diesel engine
- Cooling system
- Heating and ventilation
- Power system (carburetor)
- Power system (injector)
- Fuel injection system
- Single point injection
- Multi-point injection
- Decreased toxicity
- Engine electrical equipment
- Transmission
- Clutch
- Mechanical gearbox
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Body repair
- Body elements
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
Cookies are used to improve the site's performance. 💻 Continue by agreeing to the terms.