Note: The components for installing the control arm are shown in the illustration Front suspension.
1. Remove the appropriate wheel.
2. Loosen the nuts and bolts of the suspension ball joint and disconnect the wishbone from the steering knuckle.
3. Loosen the nuts and bolts securing the wishbone to the subframe and remove the wishbone.
Note: When removing the left arm on models with AT, lower the subframe to release the bolts. To do this, first support the subframe with a jack, release the right upper tie rod mounting bolt, the left upper tie rod mounting bolt (from the subframe side), as well as subframe mounting bolts.
4. Check the components for removal and replace them if necessary.
5. Installation is carried out in the reverse order. After installation, check the wheel alignment angles.