Back door lock assy
Removing
1. Remove the tailgate trim. See section «Exterior finish».
2. Disconnect a socket from the lock of a back door.
3. Turn off bolts and take out the lock of a back door in gathering from the panel of a back door.
4. Disconnect the connector from the tailgate opener drive.
5. Turn off fixing bolts, remove the lock of a back door in gathering.
Installation
Installation is carried out in the reverse order of removal
Attention:
- If necessary, apply body lubricant to the sliding areas on the tailgate assembly.
- After installation, check the operation.
Removal and installation of the rear door handle
Removing
1. Remove the tailgate trim. See section «Exterior finish».
2. Remove the tailgate request switch (on smart key models), remove the rear door opener switch wiring clips and disconnect the connectors.
3. Turn off nuts of the handle of a back door in gathering and remove it.
Installation
Installation is carried out in the reverse order of removal.
Attention: After installation, check the operation.
Disassembly and assembly
Loosen the screws and remove the rear door request switch (on smart key models) and rear door opener switch.