Removing
1. Raise the car and remove the wheels.
2. Roll the jack under the trailing arm of the rear suspension beam and support it. Loosen the bolts on the bottom of the shock absorber (left and right).
3. Place a jack under the transverse arm.
4. Remove the jack. Remove the spring and rubber spring seat.
Check after removal
Check for deformation, cracks and damage on the spring and the rubber spring seat. Replace defective components if necessary.
Installation
For tightening torques, see section «Components». Installation is carried out in the reverse order of removal.
When installing the spring, securely insert the end of the spring so that it is flush with the rubber spring seat as shown.