Removing
1. Raise the vehicle, remove the wheels and release the parking brake.
2. Press a brake pedal and turn away the union of prorolling of a brake of a back wheel. See chapter Brake system.
3. Drain the brake fluid. See chapter Brake system.
4. Loosen the self-locking nut and separate the rear parking brake cable from the rear wheel brake and rear suspension beam. See chapter Brake system.
5. Remove the ABS wheel sensor. See chapter Brake system.
6. Separate a hose of a back brake from a brake tube. See chapter Brake system.
7. Unscrew the mounting bolts from the underside of the shock absorber (left and right) and remove the springs (left and right).
8. Support the suspension beam with a jack and remove the mounting bolts from the suspension arm bracket and the rear suspension beam.
9. Remove suspension beam.
10. Separate brake pipes from a beam of a back suspension bracket. See chapter Brake system.
11. Turn out bolts from a half shaft and remove a back axis in gathering.
12. Remove nuts and bolts from rear suspension arm bracket. Remove the rear suspension arm bracket from the vehicle.
Check after removal
Check for deformation, cracks or damage on the rear suspension beam and bushing. Replace if necessary.
Installation
For tightening torques, see section «Components». Installation is carried out in the reverse order of removal.
For the installation of the brake tube and brake hose and tightening torques, see the chapter Brake system.
For setting the parking brake and tightening torques, see chapter Brake system.
For the installation of the ABS wheel sensor and tightening torques, see Brake system.
Fill with fresh brake fluid and bleed air. See chapter Brake system.