Table of contents: Removal ↓ Installation ↓
Removal
1. Drain the brake fluid from the reservoir and disconnect the hose from the branch pipe.
Caution: Do not spill brake fluid on painted surfaces. If fluid is spilled, wipe it off immediately and rinse the area with water.
2. Disconnect the master cylinder rod end in the passenger compartment and separate the master cylinder from the clutch pedal.
3. Remove the clamp from the master cylinder and separate the clutch pipe.
4. Turn the master cylinder 45° clockwise and remove from the vehicle.
Installation
1. Tilt the master cylinder clockwise by 45° and insert it into the installation hole. Turn it counterclockwise and fix it. The pipe should be facing upward.
2. After installation is complete, check and adjust the pedal height, then bleed the clutch tube.