1. Fuel priming pump module with main fuel level sensor and fuel filter:
- Install the O-ring into the fuel tank without twisting.
- Install the fuel priming pump module with the main fuel level sensor and fuel filter, matching the marks (A and B) on the fuel tank with the module, as shown in the figure.
Note. The arrow in the illustration points towards the front of the vehicle.
2. Quick connector:
- Check connector for damage or foreign material.
- Align the connector with the tube and insert it into it until it clicks.
- Check the reliability of the connection by pulling (A) for the fitting and for the tube to make sure that they are connected securely.
- Visually check the reliability of engagement of the locking mustache with the connector.
- Connect the wire connector.
3. Fuel tank service hatch cover:
- Check for fuel leaks before installing the service hatch cover.
- Install the service hatch cover so that the mark on the front (arrow) were directed towards the front of the vehicle.
- Install the retaining ring by turning it counterclockwise.
Check after installation
1. Turn the ignition switch to position "ON" (without starting the engine), to pressurize the fuel lines, then check all connections for leaks.
2. Start the engine at idle and check for leaks in the fuel system connections.