2. Drain coolant and engine oil.
Attention.
- Perform these procedures only on a cold engine.
- Do not allow engine oil or coolant to come into contact with the drive belt.
3. Remove the following components and assemblies:
- Front right fender.
- Generator (see chapter 12 "Engine electrical equipment").
- Front outlet.
- An exhaust manifold.
- Intake manifold.
- Fuel lines and injectors.
- Outlet of the cooling system.
- Attachment drive belt.
- Front engine cover.
- distribution shafts.
4. Loosen and then completely unscrew the cylinder head bolts in reverse order using a special wrench.
A. Release side.
B. Inlet side.
Note. The arrow points to the front of the engine.
5. Remove the cylinder head gasket.