Disassembly
1. With a punch (special tool) and suitable pullers, you-press the inner race of the bearing from the wheel hub.
2. Using a screwdriver, remove the retaining rings from the trailing arm
Caution: Do not damage the trailing arm with the screwdriver.
3. Remove the support shield from the trailing arm.
4. With a punch (special tool) press the bearing out of the trailing arm.
Examination
Wheel hub
Check for deformation, cracks or other damage on the wheel hub. If defects are found, replace the wheel hub.
Retaining rings
Check the circlips for deformation, cracks or other damage. Replace if defects are found.
Trailing arm
Check for deformation, cracks or other damage on the lever. Replace if defects are found.
Assembly
1. Using a screwdriver or similar tool, install the retaining ring from the outside into the trailing arm.
Caution: Do not damage the trailing arm with the screwdriver.
2. With a punch (special tool) press the bearing into the trailing arm.
Attention: Do not reuse the bearing, replace it with a new one.
3. Using a screwdriver or similar tool, install the retaining ring from the inside into the trailing arm.
Caution: Do not damage the trailing arm with the screwdriver.
4. Install the support plate on the trailing arm.
5. With a punch (special tool) press the wheel hub into the trailing arm.