Attention! When working, do not allow brake fluid to get into your eyes. Avoid spilling liquid on painted surfaces, store liquid in a sealed container.
1. The brake master cylinder and its reservoir are mounted on a vacuum booster inside the engine compartment. On the nutrient tank of the main brake cylinder, marks are applied, between which there should be a fluid level.
2. If you need to add fluid, wipe and unscrew the reservoir cap. Add only the recommended brand of fluid to the reservoir of the brake master cylinder; mixing fluids of different brands is not allowed, as the brakes may fail.
3. When topping up fluid, you should check for contamination of the fluid in the tank. If there is a sediment of dirt or large particles, then the fluid must be drained and replaced.
4. After the level is restored, tightly wrap the tank cap.
5. A slow drop in the fluid level is allowed due to wear of the brake linings. If frequent addition of brake fluid is required, then there is a leak in the hydraulic drive of the system, which should be repaired immediately.