Table of contents: Removal ↓ Installation ↓
Removal
1. Remove the rear side door trim. See section "Exterior finishing".
2. Remove the sealing mesh.
3. Remove the window frame guide. See section "Glass, window lifts and mirrors".
4. Support the door glass and lift it to the fully closed position.
5. Loosen the inner handle bolts, move the handle towards the rear of the vehicle, disengage the handle from the door panel and remove.
6. Disconnect the inner handle cable and the lock button cable from the inner handle.
Caution: Do not bend the ends of the lock button cable and the inner handle cable during removal and installation.
 |
 |
7. Remove the rubber bushings from the door side and unscrew the bolts (Torx T30) of the outer handle cover from the holes for the bushings.
8. Pull the outer handle to remove the outer handle cover.
9. Pull the outer handle towards the rear of the vehicle and remove it.
10. Remove the front and rear gaskets.
11. Remove the bolts (Torgx T30) from the door lock assembly.
12. Slide the outside handle bracket toward the rear of the vehicle and remove the bracket and door lock assembly.
13. Disconnect the connector from the door lock assembly.
14. Disconnect the outer handle cable from the outer handle bracket.
Installation
Installation is performed in the reverse order of removal
Attention:
- Before installing the door lock assembly, apply anti-corrosion lubricant "M-97 Super" to the seat on the body.
- When installing the door lock assembly, handle the outside handle cable with care as shown in the illustration.
- Before installation, route the outside handle bracket cable to the outside of the door lock assembly.
[Read more on the website: www.NISSANBOOK.ru]