Removing
1. Remove the front door trim. See section «Exterior finish».
2. Fully raise the front door glass.
3. Remove the sealing mesh.
4. Remove the bottom guide (back) front door. See section «Glass, windows and mirrors».
5. Disconnect the inner handle cable and lock button cable from the holder.
6. Unscrew the screws of the inner handle, slide the handle towards the rear of the car, disengage the handle from the door panel and remove.
7. Disconnect the inner handle cable and lock button cable from the inner handle.
Attention: During removal and installation, do not bend the ends of the button cable of the lock and the cable of the inner handle.
8. Remove the rubber bushings from the side of the door and unscrew the bolts (Togh T30) door lock cylinder assembly (overlays) from the bushing holes.
9. Separate the lock cylinder rod (from the side of the lock cylinder). If a door lock cylinder is not provided, go to step 9.
10. Disconnect the connector from the door antenna and door request switch and remove the wiring clamp (only on smart key models).
11. Pulling the outside handle, remove the door lock cylinder assembly.
12. Pulling the outside handle, slide it towards the rear of the vehicle and remove.
13. Remove the front and rear gaskets.
14. Turn out bolts (Togh T30) from the door lock assembly.
15. Slide the outside handle bracket towards the rear of the vehicle and remove the bracket and door lock assembly.
16. Disconnect the connector from the door lock assembly.
17. Disconnect the outer handle cable from the outer handle bracket.
Installation
Installation is carried out in the reverse order of removal.
Attention:
- Before installing the door lock assembly, apply anti-corrosion grease «M-97 Super» to the seat on the body.
- When connecting the rods, turn the rod holders until you feel a click.