2. Drive the car for ten minutes to warm up the CVT working fluid to a temperature of 50-80°C. Check the amount of CVT working fluid. Top up if necessary.
3. Apply the parking brake securely to prevent the wheels from spinning.
4. Install a tachometer that can be observed from the driver's seat during the inspection.
5. Start the engine, press the brake pedal and move the selector lever to position "D".
6. Gradually press the accelerator pedal while keeping the brake pedal pressed.
7. Quickly read the value of the automatic transmission standstill speed, then immediately remove your foot from the accelerator pedal.
Caution: Do not hold the accelerator pedal down for more than five seconds during the test.
Note: Automatic transmission parking speed: 2500-3000 rpm.
(The original is available on the web page: «www.NissanBook.ru»)
8. Move the selector lever to the "N" position.
9. Allow the CVT working fluid to cool at idle speed for one minute.
10. Repeat steps 6 through 9, moving the selector lever to the "R" position.
Results of automatic transmission parking speed test
Note.
- A: The parking speed is within the permissible values for this mode.
- H: Parking speed is higher than the permissible value.
- L: Parking speed is below the permissible value.