To disconnect the control cable from the control arm assembly, press the latches in the direction of the arrows in the figure.
To remove the control cable from the mounting bracket, pull the lock in the direction of the arrow in the figure.
When installing control rods, the following must be taken into account:
- The rocker must be in the neutral position.
- Securely fix all cables on the control levers.
- Securely fix all cables in the mounting brackets.
- Make sure the seal lips are in contact with the floor.
- Observing the direction of installation, put the knob on the wings.
Attention. Do not reuse the slide knob.
Threading with threaded bolts is not performed on a new clutch housing. Do not use other types of thread cutting, except for screwing in threaded bolts.
Attention. Do not reuse threaded bolts.
After installation, check the following:
- By moving the link in the direction of the first-second gears and in the direction of the fifth gear-reverse gear, make sure that the link returns to the neutral position on its own.
- When moving the yoke to each of the positions, make sure that the boot does not bulge or detach.