Attention:
After replacing the belt with a new one, slightly increase the tension of the new belt compared to the old one to allow for the running in of the new belt.
If the belt deflection is greater than normal, adjust the belt tension.
Before checking belt tension (after installing it) rotate the crankshaft two or more revolutions.
Make sure the belt is properly seated in the pulley grooves.
Make sure that there are no traces of grease or coolant on the belt.
Do not bend or twist the belt with excessive force.
A/C Compressor Belt
1. Remove the right engine protection from the bottom.
2. Loosen locknut (A) intermediate pulley.
3. Adjust the A/C compressor belt tension by turning the adjusting bolt (IN).
Adjustment values - see above.
4. Tighten locknut (A).
: 30,4-39,2 N-m (3.1 -4.0 kg m)
Alternator and water pump belt
1. Loosen locknut (WITH).
2. Loosen the set screws (D) generator.
bolts (D) available in 1 pc. in the front and in the back.
3. Adjust the alternator belt tension with a bolt (E).
Adjustment values - see above.
4. Tighten the nut (WITH) and bolts (D).
screw (WITH):
: 18,6-24,5 N-m (1.9-2.5 kg m)
bolts (D):
:43,1 -57,9 N-m (4.4-5.9 kg m)